IntrepidXJ's Adventure Weblog

Finished welding them on

Build this for addition support of the rear crossmember

here they are

I utilized one of the existing tail light bolts for addition support on the piece that I added

I just need to finish painting the other side, and get the right size hole saw

I removed and completed welding the corner guards i built

I got the tire carrier painted, so now it’s completely finished

the start of my new rear crossmember

started working on my rear driveshaft

one side of my frame plating is almost complete

I added some gussets to the tire carrier tonight

I welded and blended the tail lights today. Once i measure for the holes I will remove them and weld along the joint on the inside for strength (these outside welds are mostly cosmetic)

other side

I just need to weld them and cut the two 4″ holes

The second trail we hit this day was Rollins Pass East. It was definitely a nice trail….too bad it cannot be run all the way over the pass any longer.

The tire fits well