May 30 2005

Shaft & winch repair

rear shaft repaired

old snapped cable gone

new cable on


May 29 2005

Axle shafts ready for install

both front shafts

all my new alloy shafts


May 24 2005

More axle shaft assembly

I had a little more time today.

finished drivers side axle shaft

also started the passenger side


May 22 2005

Chicago4×4 @ The Badlands (5-22-05)

Had a great time. Even saw Sponge on my way home on 294.

A few pictures from the day :)


May 21 2005

M.O.R.E. Bombproof Motor Mounts are in

M.O.R.E. Bombproof Motor Mounts are in……so I can go wheeling tomorrow!

Oh uh…..that was bad!

in.


May 18 2005

Assembling Shafts

Had a few minutes today, and started assembling my alloy shafts and Longfield joints


May 18 2005

M.O.R.E. Bombproof Motor Mounts

M.O.R.E. Bombproof Motor Mounts are here! Gotta get them installed before Sunday!


May 11 2005

AWShifting AW4 Manual Shift Kit

My AWShifting AW4 Manual Shift Kit is here.


May 8 2005

Snapped Winch Cable

Also had a run-in with the “flying winch cable of doom” that some have spoken of!

Where’d the hook and loop go?

Yep, that’s right…..my cable snapped under a pretty big load. Guess what happened? It fell right to the ground. It did not snap back or anything. (No winch weight either).

Some duct tape should hold it……right?

;)

Actually, that pic was after Zach took back his cable clamps

Used the winch like that a few times the rest of the day with no problems.

Guess it’s time for a new cable.

This is just a reminder that four wheeling can be a dangerous activity if not done correctly. Especially during recovery situations.


May 8 2005

The Cliffs (5-8-05)

Went with Zach to the Cliffs today. Here’s some pictures.

Zach saying ‘hi’

Going down Cooter Trail

Found out that going UP #7 is a bit more difficult than going down

Playing on the rock course


Went both directions

Just a poser shot

…and a dry waterfall zach showed us